1. Unpack your canvas wall tent and wall tent frame. If you are using a tent floor, which is recommended, you should place the floor where you would like to set up the tent.

2. Place your frame pieces and angles in their respective locations on top of the tent floor.

3. Begin by assembling the roof section of the tent frame. After that is complete, you should attach the frame legs to only one side of the frame.

4. Unzip the doors of your wall tent to prevent strain and then drape your tent over the assembled part of the frame. Move the tent into its proper position on the frame, you can keep the sidewalls folded on the roof section to keep the tent off the ground as much as possible.

5. Lift up the side of the frame without legs and attach the remaining frame legs to the frame.

6. Pull the tent over the completed frame until you can no longer see any part of the frame. The tent should be snug on the frame but not too tight.

7. Position the sod cloth so that it is on the inside of the tent. The sod cloth should usually go underneath the tent floor.

8. You can now stake the tent down and install the ropes with tensioners. If you are expecting harsh winds or bad weather then you should also stake the tent down using the ropes.

9. Inspect your tent to ensure that it fits the frame right and also make sure that it is completely secured.